Solaina Garage Doors October 19th, 2017 - 10:48:50
Based on the requirements you may choose any one from Roller garage door Sectional garage door Side-hinged garage door or Up-and-over garage door. Roller garage doors as the name suggests roll up into the drum located just above the opening of the door. Sectional garage doors are essentially the same except that they do not protrude in the driveway making it safe for car to be parked. Side-hinged garage doors preserve the interior space of the garage room. You can optimize by studying pros and cons of aspects like these when choosing a garage door.
Wayne Dalton established in 1954 is the producer and supplier of the safest residential and commercial garage doors and garage door openers in the US. Wayne Dalton supplies two kinds of garage door openers: wall mount and ceiling mount. The wall mount openers an exclusive product from Wayne Dalton can be mounted on the wall beside the door. This helps to eliminate the chains belts screw drive and tract that usually clutter the garage ceiling. This model also helps to eliminate noise and vibration to a large extent.
In response to the inherently dangerous old style garage spring issues as above a newer and safer system for opening the overhead garage door was created. The idea was to transfer the load or weight of the door via a cable and pulley system to a vertical rod now equipped with a torsion (twisted) spring. This type of spring is installed with specialty hardware and bolts to a fixed plate at one end while the entire spring is installed around a horizontal pipe. This load balancing device is normally installed directly over the header of the garage opening. Using appropriate cables connectors and pulleys the weight of the garage door is transferred into the torsion spring system. The difference between the old style stretched spring and the newer torsion spring is the way that the spring energy is stored. With the old style stretched spring the energy is stored and released by pulling on the spring or returning the spring to its un-stretched condition.
In the past the biggest concern with operating an overhead garage door was the potential risks associated with the springs used for balancing the door weight. Pre mid 1960s garage door installations typically relied upon a pair of stretched (tensioned) springs to assist the operation of the garage door pivoting hinges. These springs became loaded (tensioned) as the door was moved into the closed position. Unloading (releasing) of the stored spring energy occurred as the door was opened to the horizontal overhead position. One of the most dangerous aspects of these spring systems was that after a period of time often without any maintenance or inspection the points of attachment of these springs would rust or become weak.