Marveille Garage Doors October 19th, 2017 - 11:09:49
In response to the inherently dangerous old style garage spring issues as above a newer and safer system for opening the overhead garage door was created. The idea was to transfer the load or weight of the door via a cable and pulley system to a vertical rod now equipped with a torsion (twisted) spring. This type of spring is installed with specialty hardware and bolts to a fixed plate at one end while the entire spring is installed around a horizontal pipe. This load balancing device is normally installed directly over the header of the garage opening. Using appropriate cables connectors and pulleys the weight of the garage door is transferred into the torsion spring system. The difference between the old style stretched spring and the newer torsion spring is the way that the spring energy is stored. With the old style stretched spring the energy is stored and released by pulling on the spring or returning the spring to its un-stretched condition.
In most installations a warning tag is left attached adjacent to the torsion spring when the garage door is installed. This tag warns of the danger associated with the stored energy of this spring and alerts untrained individuals to not attempt any repair adjustment or to even touch the spring and associated hardware. When the label that should be attached to this spring becomes damaged is removed or tampered with it is important that a new warning label be reattached immediately to show the dangers of this spring tension
The Vintage Plus line of Delden Garage Doors is a very popular and affordable carriage door. The 25 gauge steel pre-painted doors are 2 inches thick insulated with polystyrene with a vinyl backing. They are reported to have an R-value of at least 6. Obviously these doors are not meant to be used in areas that have tough winters or where you are going to heat or cool your garage. One of the problems with using polystyrene insulated panels is that this type insulation leaves gaps which reduce the effectiveness of the insulation.
With a torsion type of spring the energy is imparted or removed by rotating the spring clockwise or counter clockwise depending upon the direction of usage. With professional installation the complete loading of the torsion spring is controlled by the garage installer and is determined by the weight and size of the garage door that it is operating. When this type of torsion spring fails it remains attached and intact to the location on the horizontal control rod where it was mounted. I have not heard of or seen any torsion spring fly across a garage creating injury from failed components as with the stretched older style garage door springs. This is not to say that injuries have not occurred with the torsion style spring. The installation of this type of spring is generally safe when left to a trained garage door installation professional. Severe and serious injuries have occurred when untrained unqualified individuals have attempted to install or service this type of spring.