Emmeline Garage Workbench October 11th, 2017 - 20:15:09
In addition to the main pieces of a workbench there are many add-ons that are used to increase utility. Back and End stops might be installed to prevent things from rolling off onto the floor. Drawers shelves and risers can be added for increased storage. Electrical power strips and outlet cutouts can be incorporated into the design as well to run tools grinders drill presses etc. Vises and clamps can also be added to help secure whatever you are working on. The best place to start when choosing a design is to define the intended use. Once that is established the support structure worktop add-ons and size can be more easily selected. There are literally thousands of available workbench designs and configurations many of which will suit your needs and budget. When in doubt contact your supplier for assistance selecting an appropriate design.
If your house and garage are attached your choice in placement may be limited. Putting the garage workbench against a shared wall is a good idea for ease of electrical outlet installation. It will also be the area to give you the most warmth during cold months. Some insulation for sound should be considered so the folks in the house are not bothered by the noise. If your garage stands alone you may find it easier to select an area. Ideally place your garage workbench along a bare wall in order to have plenty of room for cabinets and shelves on one or both sides of the workbench. By positioning your workbench on the opposite wall of a window you will be provided with the most natural light.
Every work area needs a pegboard that will accommodate a variety of things from tools and cords to tapes and work aprons. Be sure to install your garage workbench against a wall that leaves you enough room for a good-sized pegboard. If necessary supplement with additional boards elsewhere in the garage. Some workbenches are available with a built-in pegboard often located along the back of the bench.
For the DIY workbench designers out there consider building it permanently to the exposed wall studs in your garage walls. This type of bench is for all intensive purpose permanent but can easily be dismantled in needed. It gives work space far more sturdy than the types found for purchase in the hardware store and can be customized as much as you want. Once you have a good idea on the size and location of your workbench its time to consider storage space for tools supplies and raw materials that you tend to work with most. You can build shelving underneath the workbench to provide enormous amounts of storage space for hobby supplies or other garage relegated storage. Cabinets or shelves above the workbench provide additional storage or you can always use pegboard to arrange tools for hanging storage.