Lucille Garage Doors October 15th, 2017 - 18:54:29
With a torsion type of spring the energy is imparted or removed by rotating the spring clockwise or counter clockwise depending upon the direction of usage. With professional installation the complete loading of the torsion spring is controlled by the garage installer and is determined by the weight and size of the garage door that it is operating. When this type of torsion spring fails it remains attached and intact to the location on the horizontal control rod where it was mounted. I have not heard of or seen any torsion spring fly across a garage creating injury from failed components as with the stretched older style garage door springs. This is not to say that injuries have not occurred with the torsion style spring. The installation of this type of spring is generally safe when left to a trained garage door installation professional. Severe and serious injuries have occurred when untrained unqualified individuals have attempted to install or service this type of spring.
Your roller garage door comes with a remote to automatically open and close it. When you are approaching the garage door you simply press the button on your remote and the door opens by the time you reach the garage. Then you drive in press the button again and the door automatically closes. The Genie garage door opener utilizes their Intellicode software that changes the passcode that is transmitted from their garage remote to the garage to open it. You never have to worry about some electronically stealing your passcode copying it and opening it without your persission.
In contrast to an overhead type of garage door be it sectional or single panel roll up doors have a totally different type of operating system. When these doors are used they can be concealed in an overhead or under mounted trough. These doors operate similarly to a roll top desk door except for how they are stored when not in the closed position. They normally coil as they are retracted and require significant gear trains to reduce the effort required to move these doors up and down into position. Often the forces needed to move these roll up doors require a reduction type of transmission that allows a very heavy door to be operated effortlessly.
In response to the inherently dangerous old style garage spring issues as above a newer and safer system for opening the overhead garage door was created. The idea was to transfer the load or weight of the door via a cable and pulley system to a vertical rod now equipped with a torsion (twisted) spring. This type of spring is installed with specialty hardware and bolts to a fixed plate at one end while the entire spring is installed around a horizontal pipe. This load balancing device is normally installed directly over the header of the garage opening. Using appropriate cables connectors and pulleys the weight of the garage door is transferred into the torsion spring system. The difference between the old style stretched spring and the newer torsion spring is the way that the spring energy is stored. With the old style stretched spring the energy is stored and released by pulling on the spring or returning the spring to its un-stretched condition.