Calandre Garage Doors August 18th, 2017 - 23:37:05
There will be times when your door may fail to operate. It happens from time-to-time no matter how well it is installed and maintained so there is no need to panic. More often that not the battery in your garage remote is dead or it is some other simple garage door repair. It is also a good idea to keep additional power back ups with you such as a manual device (generator UPS etc) or additional batteries. Or you can manually open the garage door until you figure out what the is causing the problem.
The Vintage Plus line of Delden Garage Doors is a very popular and affordable carriage door. The 25 gauge steel pre-painted doors are 2 inches thick insulated with polystyrene with a vinyl backing. They are reported to have an R-value of at least 6. Obviously these doors are not meant to be used in areas that have tough winters or where you are going to heat or cool your garage. One of the problems with using polystyrene insulated panels is that this type insulation leaves gaps which reduce the effectiveness of the insulation.
In response to the inherently dangerous old style garage spring issues as above a newer and safer system for opening the overhead garage door was created. The idea was to transfer the load or weight of the door via a cable and pulley system to a vertical rod now equipped with a torsion (twisted) spring. This type of spring is installed with specialty hardware and bolts to a fixed plate at one end while the entire spring is installed around a horizontal pipe. This load balancing device is normally installed directly over the header of the garage opening. Using appropriate cables connectors and pulleys the weight of the garage door is transferred into the torsion spring system. The difference between the old style stretched spring and the newer torsion spring is the way that the spring energy is stored. With the old style stretched spring the energy is stored and released by pulling on the spring or returning the spring to its un-stretched condition.
In the past the biggest concern with operating an overhead garage door was the potential risks associated with the springs used for balancing the door weight. Pre mid 1960s garage door installations typically relied upon a pair of stretched (tensioned) springs to assist the operation of the garage door pivoting hinges. These springs became loaded (tensioned) as the door was moved into the closed position. Unloading (releasing) of the stored spring energy occurred as the door was opened to the horizontal overhead position. One of the most dangerous aspects of these spring systems was that after a period of time often without any maintenance or inspection the points of attachment of these springs would rust or become weak.