Calandre Garage Workbench October 11th, 2017 - 19:50:27
The drawback is once damaged it may be expensive to replace. Manufactured work surfaces like MDF or particleboard is the preferred surface for industry. They are warp and splinter proof and are highly resistant to oil and moisture. They are also less expensive than hardwood and can be easily replaced if damaged. Plastic worktops provide strength chemical resistance and are non-conductive. Plastic is great for electronics assembly circuit board repair or any application that may be prone to spills. However plastic may be too slippery for woodworking and favor applications like ceramics work pottery or anything that requires moisture or chemical resistance.
Every work area needs a pegboard that will accommodate a variety of things from tools and cords to tapes and work aprons. Be sure to install your garage workbench against a wall that leaves you enough room for a good-sized pegboard. If necessary supplement with additional boards elsewhere in the garage. Some workbenches are available with a built-in pegboard often located along the back of the bench.
Workbench size height and mobility are also very important and vary by application. Sail makers may require very large work surfaces to spread out fabrics while jewelers and electronics repair shops may prefer smaller work tops for easy tool and parts access. The height also is important when choosing a design. Workbenches designed for standing work in general are higher than those intended for sitting. The worktop height is also dependent on the workers individual height. Many designs incorporate adjustable legs allowing for multiple heights application types and for leveling the worktop over uneven surfaces. For some applications mobility may be required so casters are installed allowing the workbench to be moved around. The best approach is to get a workbench that is sufficiently large for your needs has adjustable height for experimentation and is on casters if mobility is required for your specific application.
If space is an issue a fold-up garage workbench takes up little room when not in use. They are often designed with cabinet space to hang tools and hardware and the hinged bench folds into that space with its legs tucked under. When you need to work simply unfold the top prop up the legs and get to it. Select one with a leg system that is sturdy enough for your needs. Make sure to allow adequate space to work in when the bench is laid out.