Solaina Garage Doors October 17th, 2017 - 19:17:03
In contrast to an overhead type of garage door be it sectional or single panel roll up doors have a totally different type of operating system. When these doors are used they can be concealed in an overhead or under mounted trough. These doors operate similarly to a roll top desk door except for how they are stored when not in the closed position. They normally coil as they are retracted and require significant gear trains to reduce the effort required to move these doors up and down into position. Often the forces needed to move these roll up doors require a reduction type of transmission that allows a very heavy door to be operated effortlessly.
You can select form a wide range of doors so be sure to choose one based on sturdiness requirements. Depending on your sturdiness needs you can select from a wide range or doors. The door you choose will provide the insulation to keep your garage cooler in the summer and warmer in the winter. The door also secures the garage from intruders and from strong wind and other extreme weather conditions. There is also an additional safety advantage of an automatic roller garage over a manual garage door. Most are equipped with an infrared sensor that detects any type of movement when the garage is closing. When the obstruction is identified the garage stops moving downward and reverses up. This feature is great if you have young children or pets.
I have been involved in numerous garage door lawsuits where many different reasons for an injury have occurred. Having been retained as expert witness for both plaintiff and defense several common factors have been observed. In many cases unqualified individuals have attempted to repair or install garage doors. They have lacked the knowledge skills or even the basic required tools to perform the work safely and properly. I have been hired as an expert by garage door manufacturers and installers to defend claims that they are not responsible for alleged product defects. In most cases the components that failed failed as a result of abuse or improper installation on the part of the end user. As stated above the installation of many garage doors is not appropriate for an untrained person.
In response to the inherently dangerous old style garage spring issues as above a newer and safer system for opening the overhead garage door was created. The idea was to transfer the load or weight of the door via a cable and pulley system to a vertical rod now equipped with a torsion (twisted) spring. This type of spring is installed with specialty hardware and bolts to a fixed plate at one end while the entire spring is installed around a horizontal pipe. This load balancing device is normally installed directly over the header of the garage opening. Using appropriate cables connectors and pulleys the weight of the garage door is transferred into the torsion spring system. The difference between the old style stretched spring and the newer torsion spring is the way that the spring energy is stored. With the old style stretched spring the energy is stored and released by pulling on the spring or returning the spring to its un-stretched condition.