Babette Garage Workbench October 13th, 2017 - 18:47:02
Workbench size height and mobility are also very important and vary by application. Sail makers may require very large work surfaces to spread out fabrics while jewelers and electronics repair shops may prefer smaller work tops for easy tool and parts access. The height also is important when choosing a design. Workbenches designed for standing work in general are higher than those intended for sitting. The worktop height is also dependent on the workers individual height. Many designs incorporate adjustable legs allowing for multiple heights application types and for leveling the worktop over uneven surfaces. For some applications mobility may be required so casters are installed allowing the workbench to be moved around. The best approach is to get a workbench that is sufficiently large for your needs has adjustable height for experimentation and is on casters if mobility is required for your specific application.
In addition to the main pieces of a workbench there are many add-ons that are used to increase utility. Back and End stops might be installed to prevent things from rolling off onto the floor. Drawers shelves and risers can be added for increased storage. Electrical power strips and outlet cutouts can be incorporated into the design as well to run tools grinders drill presses etc. Vises and clamps can also be added to help secure whatever you are working on. The best place to start when choosing a design is to define the intended use. Once that is established the support structure worktop add-ons and size can be more easily selected. There are literally thousands of available workbench designs and configurations many of which will suit your needs and budget. When in doubt contact your supplier for assistance selecting an appropriate design.
Every work area needs a pegboard that will accommodate a variety of things from tools and cords to tapes and work aprons. Be sure to install your garage workbench against a wall that leaves you enough room for a good-sized pegboard. If necessary supplement with additional boards elsewhere in the garage. Some workbenches are available with a built-in pegboard often located along the back of the bench.
If your house and garage are attached your choice in placement may be limited. Putting the garage workbench against a shared wall is a good idea for ease of electrical outlet installation. It will also be the area to give you the most warmth during cold months. Some insulation for sound should be considered so the folks in the house are not bothered by the noise. If your garage stands alone you may find it easier to select an area. Ideally place your garage workbench along a bare wall in order to have plenty of room for cabinets and shelves on one or both sides of the workbench. By positioning your workbench on the opposite wall of a window you will be provided with the most natural light.